LPC2478 보드 및 소비 전류

기술노트 19623

아키텍처:

ARM

컴포넌트:

debugger

업데이트:

2018-02-28 오전 1:50

Introduction

This Technical Note applies to IAR Systems KickStart Kit for NXP Semiconductors’ LPC2478.

Discussion

Debugging with the LPC2478 board fails. For example, the 'J-Link Control Panel' shows a failure for overcurrent in the 'Target Power' tab.

Background

The LCD mounted on one batch of the LPC2478 board use too much power due to increased backlight. This will in turn use too much power for the debug probe to be able to power-up the board.

Solution

Use an external power adapter. Change position of EXT/JLINK jumper to EXT (pin 2-3 closed) in the lower right corner. The power input should be +(9-12V DC) / 6V AC.

Solution by modifying the board

It is also possible to change R22 from 1 Ohm to 2.2 Ohm, picture below. (Note that such a change ends the warranty of the board.)

 

All product names are trademarks or registered trademarks of their respective owners.

죄송하지만, 당사 사이트에서는 Internet Explorer를 지원하지 않습니다.보다 편안한 사이트를 위해 Chrome, Edge, Firefox 등과 같은 최신 브라우저를 사용해 주시길 부탁드립니다.