ETM 사용에서 Trace start 와 stop breakpoints 중단점

기술노트 14806

아키텍처:

ARM

컴포넌트:

debugger

업데이트:

2018-02-28 오전 1:53

Introduction

Trace start/stop breakpoints are only for ETM/ETB trace. Not for SWO trace.

Probe vs ETM/ETB

Trace start/stop breakpoints can be used with:

  1. I-jet-Trace if the target CPU supports ETM or ETB trace.
  2. I-jet if the target CPU supports ETB trace.
  3. J-Trace if the target CPU supports ETM or ETB trace.
  4. J-Link if the target CPU supports ETB trace.
  5. CMSIS-DAP if the target CPU supports ETB trace.

Note

As of IAR Embedded Workbench for ARM version 6.60, there is a misleading error message "User error: Breakpoint type is only available when using J-Trace". It really means that you do not have any of the combinations (3) or (4). The error message has been improved in releases newer than version 6.60.

 

All product names are trademarks or registered trademarks of their respective owners.

죄송하지만, 당사 사이트에서는 Internet Explorer를 지원하지 않습니다.보다 편안한 사이트를 위해 Chrome, Edge, Firefox 등과 같은 최신 브라우저를 사용해 주시길 부탁드립니다.