(LMS1) Solving compilation fails when dongle works

Technical Note 73500

Arkitekturer:

All

Komponent:

lms

Uppdaterad:

2020-11-26 17:02

Note: - This applies to legacy versions of IAR Embedded Workbench (2013 and older) which used License Management System version 1 (LMS1).

Introduction

This Technical Note describes the actions to take when compilation fails in a situation where the License Manager detects the USB dongle.

Discussion

In this situation, the IAR C/C++ Compiler fails with a copy protection message:

No license was found

However, the IAR License Manager (LMS1) recognizes the USB dongle and shows the message:

Dongle ok

Solve the situation by taking the following steps:

  1. Remove the USB dongle(s) from your PC.
  2. Uninstall the LMS1 version of the License Manager. Do this even if the License Manager installed is version 1.29.1.
  3. Clean up the dongle driver with help of Technical Note 62867. Perform these two actions, from that Technical Note:
    1. Remove and reinstall the dongle driver
    2. Remove the dongle driver support for parallel port dongles
  4. Install the latest LMS1 License Manager using Technical Note 14255.
  5. Restart your PC.
  6. After Microsoft Windows has started, insert the USB dongle.

Conclusion

The suggestion tries to solve the issue by making it sure that the latest dongle driver and LMS1 License Manager are being used.

All product names are trademarks or registered trademarks of their respective owners.

Det här innehållet finns tyvärr inte på svenska.

Vår webbplats finns främst på vårt koncernspråk engelska, förutom det innehåll för investerare som vi är lagstadgade att kommunicera på svenska. Vi rekommenderar att du besöker vår globala webbplats på engelska för att få en bättre upplevelse.

Vi stöder inte längre Internet Explorer. För att få bästa möjliga upplevelse av iar.com rekommenderar vi att du uppgraderar till en modern webbläsare som Chrome eller Edge.